grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

Kevin Teresa based in Switzerland has created a new open source stepper motor driver board with 6A / phase and 48V capabilities enabling it to drive a wide variety of stepper motors from NEMA 17 to ...

It’s fair to say that building electronic gadgets is easier now than it ever has been in the past. With low-cost modular components, there’s often just a couple dozen lines of code and a few jumper ...

MIKROE has released Stepper 28 Click, an add-on development board for controlling 2-phase bipolar stepper motors. The board ...

MIKROE has expanded its range of motor control boards with the launch of Stepper 28 Click, a compact add-on development board ...

Pocatello, Idaho — AMI Semiconductor has introduced two single-chip stepper motor driver ICs that are said to significantly reduce component count and bill of materials (BOM) cost in dynamic motion ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

Developers, makers and hobbyists that are looking for a way to control up to four motors using their Raspberry Pi mini PC. May be interested in a new control board that has been created by Justin ...