EDN

Designing a low-distortion audio output stage – Part 1: Introduction, the problem with push-pull outputs

This material originally appeared as one long article in Linear Audio Volume 2, published in September 2011. Linear Audio is a book-format audio magazine published half-yearly by Jan Didden. These ...
Electronic Design

Voltage-Mode Push-Pull Converters Deserve a Second Look

Double-ended topologies, such as push-pull, half-bridge and full-bridge, allow higher efficiencies and greater power densities compared with common single-ended topologies, such as flyback and forward ...
Nature

Push–Pull Electrolyte Design Strategy Enables High-Voltage Low-Temperature Lithium Metal Batteries

The Nature Index 2025 Research Leaders — previously known as Annual Tables — reveal the leading institutions and countries/territories in the natural and health sciences, according to their output in ...
Electronics Weekly

Nano-power magnetic switch uses TMR

Littelfuse has created a three pin magnetic switch that draws only 200nA and operates at up to 50Hz. Called LF21112TMR, the detector uses a combination of TMR (tunnelling magneto-resistance) sensing ...
EDN

Signal Chain Basics (Part 16): Understanding the analog voltage comparator

(Editor's Note: There are links to the previous parts of this series at the end, below the author's biography.) Determining if one voltage is greater than or less than another voltage is the job for a ...