For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

When you think about highly-precise actuators, stepper motors probably aren’t the first device that comes to mind. However, as [Diffraction Limited]’s sub-micron capable micro-manipulator shows, they ...

The new motor driver supports both sensor-based and sensorless control while aiding configuration with programmable flash.

Two-chip designs combining a microcontroller or DSP with a highly integrated driver IC simplify the design of a stepper-motor controller, while also enabling sophisticated control features that would ...

Haydon Kerk Motion Solutions, Inc., a premier manufacturer of engineered linear motion products, announces the addition of stepper motor drivers available for 24 hour shipment. A variety of stepper ...

Toshiba has launched an 4 x 4mm QFN24 stepper motor driver that can run from 4.5 to 33V and deliver up to 1.2A. Typical on-resistance of the output block is 1.2Ω. “It is well suited for ...

Oriental Motor is pleased to announce the arrival of the EtherNet/IP communication protocol to the αSTEP AZ Series AC Input stepper motor drivers. This new EtherNet ...